Owner`s manual

SETUP AND CALIBRATION, CONT.
EOP=
(END OF PRINT LINEFEEDS)
At the end of data sent to a printer, the indicator can send a number of line feed commands
to space the paper in the printer to a desired position for withdrawal or for the next print.
With display showing
EOP=
, press PRINT/ENTER key to show current setting. If value
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise using numeric keys,
enter a new value and then press PRINT/ENTER key to save it. Allowable values are: 00
through 99.
BAUD=
(SERIAL OUTPUT BAUD RATE)
With display showing
baUd=
, press PRINT/ENTER key to show current setting. If value
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise using numeric keys,
enter a new value and then press PRINT/ENTER key to save it. Allowable values are: 0, 1,
2, 3, 4 or 5.
0 = 1200 Baud 1 = 2400 Baud 2 = 4800 Baud
3 = 9600 Baud 4 = 19.2k Baud 5 = 38.4k Baud
PPORT
(PRINTER OR DATA PORT)
With display showing
PPORT
, press PRINT/ENTER key to show current setting. If value
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise using numeric keys,
enter a new value and then press PRINT/ENTER key to save it. Allowable values are:
1 = Serial Port 2 = Ethernet (requires 758-IP option) 3 = USB Device Port
Cont1
(CONTINUOUS OUTPUT SERIAL PORT)
With display showing
COnt1
, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = Serial Port Continuous
Output is Disabled
1 = Serial Port Continuous
Output is Enabled
COnt2
(CONTINOUS OUTPUT ETHERNET PORT)
With display showing
COnt2
, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = Ethernet Port Continuous
Output is Disabled
1 = Ethernet Port Continuous
Output is Enabled
COnt3
(CONTINOUS OUTPUT USB DEVICE PORT)
With display showing
COnt3
, press PRINT/ENTER key to show current setting. If setting
displayed is acceptable, press PRINT/ENTER key to save it. Otherwise use numeric keys
0/NO or 1/YES and enter a new setting. Press PRINT/ENTER key to save it.
0 = USB Device Port Continuous
Output is Disabled
1 = USB Device Port Continuous
Output is Enable
8555-M210-O1 Rev R y 758C Owner’s
27