Instruction manual

8526-M256-O1 Rev B • CS Series
4
T
KEY FUNCTIONS, CONT.
M+
Pressing the M+ key will cause the scale to display the contents of the
accumulator (the number of pieces accumulated since the last time the
accumulator was cleared).
The M+ key is also used to add the current piece count value to the
accumulator. The M+ annunciator will be selected to indicate the accumulation
has taken place.
TARE
The TARE key is used to display the current tare weight (or zero if no tare has
been entered) and/or using the numeric keypad, to enter a new tare weight. It is
also used when entering a tare under a Preset number.
MC The MC key is used to clear the accumulator. The M+ and ADD annunciators
will turn off to indicate the clearing has taken place.
0 ~ 9
These keys are used to enter numeric data during normal operations as well as
during calibration and operational setup.
A to Z
Space
(
9
)
These keys are used to enter the letters A to Z and Space (
9
) for the
descriptions of ID’s and Items. Up to 12 digits can be used for the description.
x
This is the decimal point key. It is used to enter a decimal point where required
when entering numeric data.
CE The CE key is used to perform different functions depending on the current
mode of operation:
• Data Entry: The CE key is used to clear an incorrect entry from the
display without processing the data. If an incorrect entry is made, press
the CE key and re-enter the correct data.
• Count Mode: Pressing the CE key while in the Count mode will finish the
counting operation, update the quantity and weight accumulators and
return the scale to the Weight mode.