Instruction manual

8526-M256-O1 Rev B • CS Series
3
KEY FUNCTIONS
This section describes the use of each of the keys on the Digital Counting Scale. It will be
helpful to refer to the scale keyboard or the figure below when reading this section.
The membrane keyboard is not to be operated with pointed objects (pencils,
pens, fingernails, etc). Damage to keyboard resulting from this practice will
NOT be covered under warranty.
SAMPLE
SIZE
This key is used to weigh a known number of pieces in preparation for a new
counting operation. Sample quantities are entered using the numeric keypad in
any quantity desired.
COUNT
PRESET
This key is used when setting the Quantity and Weight Preset limits. During a
counting operation (with the limits set) if the quantity or weight exceeds the
limits, the error beeper will sound and an error message will flash on the display.
SAMPLE
WEIGHT
Pressing this key will display the calculated average piece weight from the
current sampling and counting operation. It will also allow the manual entry of
a known average piece weight (using the numeric keys) to be used in the next
counting operation.
UNITS
Pressing this key will toggle the weighing units between pounds (lb) and
kilograms (kg). NOTE! The currently selected weighing unit is indicated by
illuminating either the lb or kg annunciator.
Æ0Å
ZERO
The ZERO key is used to perform a variety of functions depending on the
current mode of operation:
Weight Display Mode (lb or kg annunciator on): Pressing the ZERO key will set
the weight display to zero and turn on the ZERO annunciator if the displayed
weight is within ± 4% of scale capacity.
Calibration and Operational Setup Mode: Pressing the ZERO key and then
pressing the setup parameter number on the numeric keypad while "&% is
displayed will enter that setup mode.