Instruction manual

8526-M256-O1 Rev B • CS Series

INSTALLATION

Unpacking

Before beginning installation of your CS Series Digital Counting Scale, make certain the

instrument has been received in good condition. Carefully remove the instrument from the

shipping carton and inspect it for any evidence of damage (such as exterior dents or

scratches) that may have taken place during shipment. Keep the carton and packing

material for return shipment if it should become necessary. It is the responsibility of the

purchaser to file all claims for any damages or loss incurred during transit.

Placement

Place the scale on a stable, vibration-free level surface away from direct sunlight and from

any rapidly moving air source (heating/cooling vents, fans, etc.). Make certain the power

cord and peripheral cables are routed out of the way of normal traffic.

CAUTION! DO NOT place the scale on any unstable cart, stand or table. The

scale may fall causing injury to the operator, and seriously damage the unit,

or proper operation of the scale may be inhibited.

Level Adjustment

Check to make certain the scale is level. The level indicator is

located at the front of the scale. If the scale is not level (the bubble

will not be centered), loosen the locking ring on all four (4) mounting

feet and adjust them as required to center the bubble and attain a

level scale. Once a level condition has been obtained, lock the

mounting feet in place by tightening the adjustment locking rings

against the bottom of the scale.

Power Connection

The scale contains a power supply that converts the 110/120/220/240 VAC 50/60Hz wall

supply to the power required by the scale circuitry. The power supply also contains the

circuitry necessary to monitor and recharge the battery and is capable of operating the scale

and recharging the battery simultaneously.

AC Operation

Plug the power cord into a grounded, polarized wall receptacle that supplies 110/120 VAC

50/60Hz power. If it is necessary to use an extension cord, make certain it is a 3-wire, fully

grounded type using a minimum of 18-gauge wire. Be certain the power cord is routed out

of the way of normal traffic. If only an ungrounded wall receptacle is available, it is the

customer’s responsibility to contact a qualified electrician to replace the ungrounded

receptacle with a properly grounded polarized wall receptacle or have a grounding adapter

properly installed.

CAUTION! To avoid electrical hazard, DO NOT under any circumstances,

cut, remove, alter, or in any way bypass the power cord-grounding prong.

It is the responsibility of the customer to contact a qualified electrician to install the

proper power cord connector. Plug the power cord into a grounded, polarized wall

receptacle that supplies 220/240 VAC 50/60Hz power. Be certain the power cord is routed

out of the way of normal traffic.

Not Level Level