Instruction manual

8526-M256-O1 Rev B • CS Series
25
RS232 AND SERIAL PRINTER SETUP, CONT.
9:` – Zero Reset Condition for Automatic Transmission Setting
1. With the WEIGHT display showing 9:` (with the 6 flashing), use the
alphanumeric keypad to enter 0 and 7.
2. The WEIGHT display will change to 9:` with the 7 flashing.
3. Press the MC key.
4. The PIECE WEIGHT display will change to show the current setting.
5. If the setting displayed is acceptable, press the MC key to save it.
6. Otherwise, using the numeric keys, enter the desired setting for the Zero Reset
Condition for Automatic Transmission Condition and press the MC key to save it.
Available values are 00 through 02.
`
= External value “0d”
`
= External value “0d”
`
= External value “0d”
• The range setting of 9:` is related to the zero reset setting in
accumulation acceptable condition in 0`.
• Only if the 9:` setting is set as  will 9:` setting be effective.
9:` – Reset Condition for Automatic Transmission Setting
1. With the WEIGHT display showing 9:` (with the 7 flashing), use the
alphanumeric keypad to enter 0 and 8.
2. The WEIGHT display will change to 9:` with the 8 flashing.
3. Press the MC key.
4. The PIECE WEIGHT display will change to show the current setting.
5. If the setting displayed is acceptable, press the MC key to save it.
6. Otherwise, using the numeric keys, enter the desired setting for the Zero Reset
Condition for Automatic Transmission Condition and press the MC key to save it.
Available values are 00 through 02.
`
= External value “0d”
`
= External value “0d”
`
= External value “0d”
• Only if 9:` setting is set as  “automatic transmission mode” will
9:``setting be effective