Instruction manual

8526-M256-O1 Rev B • CS Series
23
RS232 AND SERIAL PRINTER SETUP, CONT.
9:` – Output Counts Setting per Second in Continuous Transmission
1. With the WEIGHT display showing 9:` (with the 3 flashing), use the
alphanumeric keypad to enter 0 and 4.
2. The WEIGHT display will change to 9:` with the 4 flashing.
3. Press the MC key.
4. The PIECE WEIGHT display will change to show the current setting.
5. If the setting displayed is acceptable, press the MC key to save it.
6. Otherwise, using the numeric keys, enter the desired setting for the Output Counts per
Second in Continuous Transmission and press the MC key to save it. Available
values are 00 through 04.
`
= 1 count/second
`
= 2 counts/second
`
= 4 counts/second
`
= 8 counts/second
`
= More than 8 counts/second
• If 9:` is set as  (fixed format 1) or  (fixed format 2), the continuous
transmission mode may only work with short distances.
• If 9:` is set as  (Reserved), continuous transmission mode is not
available.
• If 9:` is set as  through , continuous transmission mode is available.