Instruction manual

8526-M256-O1 Rev B • CS Series
10
OPERATION, CONT.
Accumulator
Adding to the Weight Accumulator
1. With the scale in the Weight mode, place the item on the scale platform.
2. Press the M+ key to add to the value of the Weight Accumulator.
3. The PIECE WEIGHT display will flash 33, then change to show the accumulator
values (to indicate the addition to the accumulator has taken place). After 3 seconds,
the scale will return to the weight mode.
4. Remove the item from the scale.
5. The scale is ready for the next counting or weight operation.
Additional Weight Accumulator additions cannot take place until the current
weighing operation (scale weight returns to zero) has been completed.
Refer to Operational Setup, M+ Key Continuous Operation (1, 5).
Displaying the Accumulator
With the scale in the Weight mode, press the M+ key to display the content of the
accumulators. The values of the accumulator will be displayed for 3 seconds, then return
to the Weight mode display.
Clearing the Accumulator
Press the MC key. The accumulator will be reset to zero.