Instruction manual

8526-M256-O1 Rev B • CS Series
8
OPERATION, CONT.
Counting
Weight of Sample is Unknown
1. With the scale in the Weight mode, place the sample on the scale platform.
2. On the numeric keypad, enter the number of pieces in the sample.
3. While the display is blinking, press the SAMPLE SIZE key.
4. Add the pieces to be counted and read the total count on the COUNT display.
5. Remove the pieces from the scale.
6. Press the CE key to complete the counting operation and return to the Weight mode.
Sample Weight is Known
1. With the scale in the Weight mode, using the numeric keypad, enter the piece weight of
the sample.
2. Press the SAMPLE WEIGHT key.
3. Add the pieces to be counted and read the total count on the COUNT display.
4. Remove the pieces from the scale.
5. Press the CE key to complete the counting operation and return to the Weight mode.
Counting With an Insufficient Sample
1. With the scale in the Weight mode, place the sample on the scale platform.
2. On the numeric keypad, enter the number of pieces in the sample.
3. While the display is blinking, press the SAMPLE SIZE key.
4. If the sample weight is too small, the INSUF SAMPLE and ADD annunciators will be
turned on and the COUNT display will show the number of pieces to be added.
5. Add the number of pieces requested. Note that if the pieces are
not added the INSUF
SAMPLE annunciator will stay on to show the out-of-tolerance count.
6. Add the pieces to be counted and read the count.
7. Press the CE key to complete the counting operation and return to the Weight mode.