Specifications
8200-M538-O1 Rev C y 225 Installation & Technical
67
CALIBRATION AND SETUP, CONT.
%08670+65::: (CONVERTED UNITS)
With SCALE 1 SETUP MENU #1 displayed the current setting for the %08670+65
parameter will be shown. Note that X is the current value and XX is the description. If
the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 2 key, the ENTER key and then using the numeric keys, enter the
value for the converted units and then press the ENTER key to save the new setting
and return to SCALE 1 SETUP MENU #1. Allowable values are 0 through 7.
BASE and CONVERTED UNITS SELECTIONS
0 = none 3 = lb (pounds) 6 = t (tonnes “metric tons”)
1 = tn (tons) 4 = oz (ounces) 7 = Custom Units
2 = g (grams) 5 = kg (kilograms (see note below)
NOTE! The following prompts, %08( (Conversion Factor) and .#$'. (Label) will
only be displayed if you selected 7 (Custom Units) for the %08670+65(Converted
Units) prompt.
%08( – CONVERSION FACTOR
The conversion factor is a number that the base units must be multiplied by to obtain
the desired unit of measurement. The display will show %08(:::::::, where
XX.XXXXX is the current setting for the converted units conversion factor.
EXAMPLE:
Water weighs 8 lb per 1 Gallon.
To compute the conversion factor, you would divide 1 gallon by 8 pounds, with the
result being 0.125.
1 Gal
8 lb
Therefore, if the weight displayed is ND), pressing the UNITS/TEST key
would change the display to show IN). (27.65 x 0.125 = 3.45625). The
IN in the example stands for gallons. Refer to the next prompt, .#$'., for
information on entering the custom units label.
To accept the value displayed, press the ENTER key, otherwise, use the numeric keys
to enter a new value then press the ENTER key to save it.
= 0.125