Specifications
8200-M538-O1 Rev C y 225 Installation & Technical
57
CALIBRATION AND SETUP, CONT.
6JTGU9V::::::: (THRESHOLD WEIGHT FOR AUTO MODE)
With the COM 1 SETUP MENU displayed the current setting for the 6JTGU9V
parameter will be shown. Note that XXXXXXX is the current value. If the setting
displayed is acceptable, press EXIT (Navigation Keys U UP Arrow) to return to the
Serial Menu.
Otherwise, press the 1 and 0 keys, the ENTER key and then using the numeric keys,
enter the value for the threshold weight
1
used to control the traffic light auto mode and
then press the ENTER key to save the new setting and return to the COM 1 SETUP
MENU. Note that entering 0 disables the traffic light auto mode.
1
If scale gross weight is less than or equal to threshold weight, traffic light will be Green.
When scale gross weight is greater than threshold weight, traffic light will be Red.
NOTE! If manual light mode is disabled (/CPWCN/QFG01) and 0 is entered
for the threshold weight (6JTGU9V), the traffic light feature will be disabled
(turned off).
COM1 (Serial Port 1) Setup Completed
The COM1 (Serial Port 1) setup has been completed, press EXIT (Navigation Keys U UP
Arrow) to return to the Serial Menu and proceed to the COM2 or COM3 port setup.
5GTKCN/GPW
24+06'4
%1/
%1/
%1/
'PVGT5GNGEVKQP@':+6
When setup of the PRINTER port and all of the COM ports has been completed, press EXIT
(Navigation Keys U UP Arrow) to exit and return to the SETUP MENU #2.
With the SETUP MENU #2 displayed,
y Proceed to the next setup parameter.
y Press PREV (Navigation Keys U UP Arrow) to return to SETUP MENU #1.
y Press NEXT (Navigation Keys V Down Arrow) to proceed to the SETUP MENU #3.