Specifications
8200-M538-O1 Rev C y 225 Installation & Technical
54
CALIBRATION AND SETUP, CONT.
2#4+6;::::: (COM1 PARITY RATE)
With the COM1 SETUP MENU displayed the current setting for the 2#4+6;
parameter will be shown. Note that X is the current value and XXXX is the description.
If the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 2 key, the ENTER key and then using the numeric keys, enter the
value for the printer parity rate and then press the ENTER key to save the new setting
and return to the COM1 SETUP MENU. Allowable values are 0, 1 or 2.
0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity
$+65: (COM1 DATA BITS)
With the COM1 SETUP MENU displayed the current setting for the $+65 parameter
will be shown. Note that X is the current value. If the setting displayed is acceptable,
proceed to the next setup parameter.
Otherwise, press the 3 key, the ENTER key and then using the numeric keys, enter the
value for the printer data bits and then press the ENTER key to save the new setting
and return to the COM1 SETUP MENU. Allowable values are 7 or 8.
56125: (COM1 STOP BITS)
With the COM1 SETUP MENU displayed the current setting for the 56125
parameter will be shown. Note that X is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
Otherwise, press the 4 key, the ENTER key and then using the numeric keys, enter the
value for the printer stop bits and then press the ENTER key to save the new setting
and return to the COM1 SETUP MENU. Allowable values are 1 or 2.
%106::: (COM1 CONTINUOUS OUTPUT)
With the COM1 SETUP MENU displayed the current setting for the %106 parameter
will be shown. Note that XXX is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
Otherwise, press the 5 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the COM1 SETUP MENU.
%106;'5 %10601
Continuous Output Enabled Continuous Output Disabled