Specifications

8200-M538-O1 Rev C y 225 Installation & Technical
45
CALIBRATION AND SETUP, CONT.
1+/.::: (PROTECTIVE INTERFACE)
NOTE! If the 225 is used in a country where the application requires a protective
interface, the 75# parameter must be set for international use (75#01) to allow
the 1+/.::: setup parameter selection.
With SETUP MENU #1 displayed the current setting for the 1+/. parameter will be
shown. Note that XXX is the current value. If the setting displayed is acceptable, proceed
to the next setup parameter.
Otherwise, press the 4 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
1+/.;'5 1+/.01
Protective Interface Enabled Protective Interface Disabled
NOTE! When YES is selected, serial port COM1 will be dedicated to outputting scale gross
weight whenever the application is executing.
6+/':: (CLOCK TIME FORMAT)
With SETUP MENU #1 displayed the current setting for the 6+/' parameter will be
shown. Note that XX is the current value. If the setting displayed is acceptable, proceed to
the next setup parameter.
Otherwise, press the 5 key, the ENTER key and then using the numeric keys, enter 12 or 24
and then press the ENTER key to save the new setting and return to the SETUP MENU #1.
6+/' 6+/'
12 hour clock (AM/PM)
(8:30 PM will print as 08:30 PM)
24 hour clock
(8:30 PM will print as 20:30)
%.46#4'::: (CLEAR TARE)
With SETUP MENU #1 displayed the current setting for the %.46#4' parameter will be
shown. Note that XXX is the current value. If the setting displayed is acceptable, proceed
to the next setup parameter.
Otherwise, press the 6 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
%.46#4';'5 %.46#4'01
Automatically clears Stored Tare
when Net weight goes below zero
Stored Tare is not cleared when
Net weight goes below zero
The following is a typical example of the Clear Tare feature in use.
1. Place container on scale, then press the TARE key.
2. Load container with item to be weighed and perform normal weighing operation.
3. Remove load (item AND container) from scale.
4. Scale weight returns to below zero (weight of container) and is then reset to zero.
5. Operator is required to repeat step 1 before next weighing operation.