Specifications
8200-M538-O1 Rev C y 225 Installation & Technical
44
CALIBRATION AND SETUP, CONT.
05%::: (AUSTRALIA NSC REQUIREMENTS)
NOTE! In countries requiring the 225 to meet Australia NSC requirements, the 75#
parameter must be set for international use (75#01) to allow the 05%:::
setup parameter selection.
With SETUP MENU #1 displayed the current setting for the 05% parameter will be shown.
Note that XXX is the current value. If the setting displayed is acceptable, proceed to the
next setup parameter.
Otherwise, press the 2 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
05%;'5 05%01
Australia NSC Requirements
Enabled
Australia NSC Requirements
Disabled
.(6::: (LEGAL FOR TRADE)
With SETUP MENU #1 displayed the current setting for the .(6 parameter will be shown.
Note that XXX is the current value. If the setting displayed is acceptable, proceed to the
next setup parameter.
Otherwise, press the 3 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
.(6;'5 .(601
Interval Settings (+06'48#.)
allowed are 1, 2, 5, 10, 20, 50
Interval Setting (+06'48#.) is
selectable from 1 to 99.
NOTE! If .(6;'5and 75#;'5
NOTE! If .(601
Division must be 100 to 10,000
<64#%-= .5 or 0 to 3
Inhibit serial data during input
'= MM/DD/YY
Enables the Converted Units Net
Weight print feature
<.+/+6= NO
%#2+ 5% to OC
NOTE! If .(6;'5 and 75#01
56#$.'= 1
'= DD/MM/YY
<64#%- = 0.5
<.+/+6= yes
%#2 + 9 grads to OC
PT printed with tare
Lamp test on power up