Installation Guide

_________________________________________________________________________________________________________________________
Card Access
™
InHome
™
Heavy-Duty Power Controller Installation Guide / Wiring Diagram Page 5 of 12
Card Access, Inc.
Option 2: Used where each load uses its own external circuit breaker
Option 3: Used where a combination of power sources are used; load “A” is powered by an external breaker in the load
path and load “B” is powered by the devices external breaker or power source.
For a Control4 Operating Mode installation of the InHome Heavy-Duty Power Controller, you must perform the following
steps:
Control4 Operating Mode Installation
Hardware Installation Instructions
!!! WARNING !!!: An accessible disconnect device shall be installed