Specifications

4
Specifications
Power Cord 6.56’ (2m) Shipping Height 15.5” (39 cm)
Power Supply 12 volt DC Shipping Width 13.5” (34 cm)
Mixture Reservoir 2 L ( 2.1 Qt. ) Shipping Depth 18.5” (47 cm)
PART NO. QTY DESCRIPTION
060-1400 2 Utilizing 5/16” Fuel Line Female - General Application
060-1600 1 12mm Banjo Fitting
060-2300 1 17mm Wrench Size With 14mm Threads - Inlet/Return
060-2401 1 8mm Banjo Fitting
060-2402 1 14mm Banjo Fitting
060-2600 1 19mm Wrench Size With 16mm Threads - Inlet/Return
060-2501 1 Forms “Tank to Tank” Loop On All Vehicles
Part No. 200-0002
The MotorVac “S-Tool Canister” helps you perform an effective
induction service on direct or conventional fuel injected
engines. After filling the tool’s cylinder with MotorVac MV4
detergent, it is pressurized using shop air. The S-Tool is
placed inside the intake past the mass air flow sensor and
a fine spray of detergent is introduced into the system.
• Air intake plenum, throttle body and intake runners
are cleaned and lubricated with MV4 detergent.
• Efficient process results in a highly affordable
and profitable add-on service.
S-Tool Canister
Induction Service for Gasoline Engines
RECOMMENDED CHEMICAL MV3 Part No. 400-0020
CARBONCLEAN SYSTEM II
Part No. 500-0200
MotorVac’s two-line cleaning system connects to the engine
using vehicle specific adapters, temporarily replacing the
vehicle’s fuel system. During the first cleaning phase
(with the engine off) the system circulates MotorVac’s
powerful yet safe proprietary cleaning MV3 detergent mixed
with gasoline through the components of the engine’s fuel
system. This phase safely dissolves contaminants, gum and
varnish deposits, capturing them in the unit’s ten micron filter.
• Works on port-fuel, TBI, CIS, and carburated systems.
• Safely dissolves contaminants, gum and varnish
deposits, capturing them in the unit’s ten micron filter.
• Injector screens, intake & exhaust valves, top of pistons,
combustion chamber, oxygen sensor and catalytic
converter are cleaned.
CarbonClean
System II
Carbon Fuel System Service Center
PART NO. 200-8058 STANDARD ADAPTERS (INCLUDED)
Specifications
Overall Diameter 4” (10 cm) Maximum Pressure 200 PSI
Overall Height 8” (20 cm) Maximum Capacity 32 oz.
S-TOOL CANISTER
RECOMMENDED CHEMICAL MV4 Part No. 400-0030