Technical data

TM 9-1005-319-23&P 0001
0001-7/8 blank
QUALITY OF MATERIAL
Material used for replacement, repair, or modification must meet the requirements of this TM 9-1005-319-
23&P. If quality of material requirements is not stated in this TM 9-1005-319-23&P, the material must
meet the requirements of the drawings, standards, specifications, or approved engineering change proposals
applicable to the subject equipment.
SUPPORTING INFORMATION FOR REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Common Tools and Equipment
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE); CTA 50-970, Expendable/Durable Items (Except: Medical, Class V, Repair Parts, and Heraldic
Items); CTA 50-909, Field and Garrison Furnishings and Equipment; or CTA 8-100, Army Medical
Department Expendable/Durable Items, as applicable to your unit.
Air Force users should maintain the following common tools:
Ball-peen hammer
Combination wrench
Flat file
Flat-tip screwdriver
Hammer
Machinist's vise
Needle nose pliers
Punch
Retaining ring pliers
Socket wrench handle and socket head screw socket wrench
Solid center punch
Torque wrench
Trigger pull test fixture rod and weights
Tweezers/round nose pliers
Vise jaw caps
3-ounce soft-brass hammer
1/16-inch drive pin punch
5/64-inch drive pin punch
3/32-inch drive pin punch
1/8-inch drive pin punch
8-inch adjustable wrench (2)
Special Tools, TMDE, and Support Equipment
Special tools required for field maintenance are listed in WP 0039 and WP 0044. Fabricated tools are listed
and illustrated in WP 0030.
Repair Parts
Repair parts are listed and illustrated in the parts information work package WP 0039 of this manual.
END OF WORK PACKAGE