Technical data

TM 9-1005-319-23&P 0025
0025-3
CARBINE ONLY
NOTE
Use wooden vise jaws in place of brass vise jaw caps.
1 v s 2 0 9
8
9
1 1
1 2
2
1 3
1 5
1 4
1 0
Figure 3. Removal of Lower Receiver Extension (Carbine).
5. Clamp lower receiver (2) in vise and tighten on solid portion just tight enough to hold.
6. Loosen round plain nut (9) using spanner wrench (WP 0039, figure 23, item 13). Catch headless
straight pin (14) and helical spring (15).
CAUTION
While performing the following step, care should be taken to restrain the pivot pin
spring and detent.
7. Loosen round plain nut (9) to allow receiver end plate (10) to disengage from lower receiver (2).
Remove takedown pin (13), buffer retainer (11), and helical spring (12). Unscrew lower receiver
extension (8) from lower receiver.
END OF TASK