Technical data

TM 9-1005-319-23&P 0020
0020-2
REPAIR OR REPLACEMENT
1. Inspect forward assist pawl (1) for burrs, chips, and cracks. Minor burrs may be removed using fine
files or stones, as required. Do not deform forward assist pawl. Replace if defective.
2. Inspect pawl detent (2) for burrs and cracks. Minor burrs may be removed using fine files or stones, as
required. Do not deform pawl detent. Replace if defective.
3. Inspect helical spring (3) for kinks, breaks, and wear. Replace helical spring if defective.
4. Inspect plunger assembly (4) for wear, burrs, chips, and breaks. Minor burrs may be removed using
fine files or stones, as required. Do not deform plunger assembly. Replace forward assist assembly if
defective.
5. Inspect spring pin (5) for wear. Replace if defective.
END OF TASK
LUBRICATION
Lubricate helical spring, pawl detent, and forward assist pawl with cleaner, lubricant, and preservative
(CLP) (WP 0045, item 9) before installation.
ASSEMBLY
1 v s 1 6 8
1
2
3
4
5
Figure 2. Assembly of Forward Assist Assembly.
WARNING
To avoid injury to eyes, use care when installing spring-loaded parts.
1. Install helical spring (3), pawl detent (2), and forward assist pawl (1) into plunger assembly (4).
2. Align holes and install spring pin (5) using 1/16 in. drive pin punch and hammer. Spring pin must be
flush or slightly below flush after reassembly.
3. Assemble rifle; refer to page TM 9-1005-319-10.
END OF TASK
END OF WORK PACKAGE