Technical data

TM 9-1005-319-23&P 0017
0017-2
DISASSEMBLY - Continued
1 v s 1 4 8
O L D
N E W
5
7
1
2
3
4
6
Figure 2. Disassembly/Assembly of Handguard Assembly.
1. If damaged, remove slotted screw (2) from upper handguard (3).
2. Taking care not to damage rails, drive out spring pin (7) using 1/8 in. punch and hammer. Remove rear
handguard clamp (1). Discard spring pin.
3. Taking care not to damage rails, drive out spring pin (6) using 1/8 in. punch and hammer. Remove
special shaped spacer (5) and flat spring (4). Discard spring pin.
9
9
8
1 v s 1 4 9
Figure 3. Repair of Barrel Stop Assembly.
4. If damaged, remove two helical compression springs (9) from barrel stop (8) turning counterclockwise
with needle nose pliers.
END OF TASK