Technical data

TM 9-1005-319-23&P 0016
0016-10
ASSEMBLY - Continued
1 v s 1 4 5
Figure 11. Adjustment of Front Sight Post.
b. Using a dummy round or front sight post tool, adjust front sight so top of front sight post is 5mm
above machined surfaces of front sight frame.
5 M M
1 v s 1 4 6
Figure 12. Final Measurement of Height.
c. Visually check front sight post top height by using the marked plastic or paper card. Card must sit
level on machined surfaces of front sight frame to obtain an accurate reading.
END OF TASK
END OF WORK PACKAGE