Technical data

TM 9-1005-319-23&P 0015
0015-12
REPAIR OR REPLACEMENT - Continued
S H I N Y S U R F A C E S
( R E P A R A B L E )
1 v s 1 1 7
Figure 17. Inspection for Shiny Surfaces.
WARNING
SOLID FILM LUBRICANT
CAUTION
Solid film lubricant is to be used only as an exterior surface protective finish and
touchup. If solid film lubricant comes in contact with recoiling parts or functional
surfaces of the weapon, remove immediately by washing with technical
dichloromethane.
5. Repair shiny surfaces by spraying a coat of solid film lubricant (WP 0045, item 20) in accordance with
instructions supplied by the manufacturer. Dry 24 hours before handling.
6. Inspect all parts for damage and wear. Replace all defective parts as authorized by WP 0039.
NOTE
Damaged or missing teeth of the barrel nut is not cause for rejection provided the
proper torque value can be obtained during installation using the identified tools. If
removal of the barrel is not possible with the combination tool, a pipe wrench or other
similar tool may be used during removal.
END OF TASK