Technical data

TM 9-1005-319-23&P 0012
0012-8
ASSEMBLY - Continued
1 v s 0 9 1
4
5
6
7
Figure 11. Installation of Spring Pin.
5. Compress and hold ejector spring (6) and cartridge ejector (7) in place with a 3/8 in. punch.
6. Using hammer and 1/16 in. punch, complete installation of spring pin (5) so that ends are flush with
outside of bolt (4).
1 v s 0 9 2
3
2
Figure 12. Installation of Extractor Spring Assembly.
NOTE
Do not disassemble rubber insert from extractor spring assembly.
7. If removed, insert large end of extractor spring assembly (3) into cartridge extractor (2) and seat by
pushing and turning clockwise.