Technical data

TM 9-1005-319-23&P 0012
0012-3
CAUTION
Be sure to use vise jaw protective caps.
3. Hold bolt (4) in vise and remove spring pin (5) using 1/16 in. punch and hammer.
1 v s 0 8 3
6
7
Figure 3. Removal of Cartridge Ejector.
4. Remove punch; be sure to catch cartridge ejector (7) and ejector spring (6) to prevent loss.
1 v s 0 8 4
8
4
Figure 4. Removal of Bolt Rings.
NOTE
Do not remove bolt rings unless they require replacement and three new replacement
bolt rings are on hand.
5. Using flat tip jeweler's screwdriver, remove three bolt rings (8) from bolt (4).
END OF TASK
CLEANING
CAUTION
Do not distort extractor spring assembly during cleaning.
Clean all items; refer to TM 9-1005-319-10. Remove carbon deposits.
END OF TASK