Data Sheet

5/3/2018 Shapeoko 3 T-track installation - Carbide 3D

http://docs.carbide3d.com/assembly/t-tracks/s3/ 3/5

NOTE:The T-tracks are not symmetric front to back. See the image above to identify what

is the front and what is the back.

Take one of the  provided T-tracks, and align it with the front edge. Keep this T-track pressed

against the side ﬁller strip. There should be no gap.

Continue with this same method by next laying down a middle ﬁller strip, then another T-track,

then another middle ﬁller strip, then another T-track, then the last side ﬁller.

When you get to the end, there should be a small gap between the side ﬁller strips and the

eccentric nuts on both Y-axis plates.

Prep