Data Sheet

5/3/2018 Shapeoko 3 T-track installation - Carbide 3D
http://docs.carbide3d.com/assembly/t-tracks/s3/ 2/5
Item Description  Qty 
Middle
Filler
7.25 x 23”,
MDF
- 2 
#8 x 1/2”
Screw
(to secure T-
tracks)
- 50 
#8 x 1-
1/4”
Screw
(to secure
filler strips)
- 30 
#2
Phillips
Driver
(magnetic,
1/4” hex)
- 1 
5/64”
Drill Bit
(to pre-drill
screw holes)
- 1 
Layout
NOTE:The gantry for this machine has been removed for clarity. You do not need to
remove the gantry of your machine in order to install this kit!
Beginning on the left side of the machine, place one Side Filler strip -/” from the edge and
flush with the front of the table. It is helpful to clamp this piece in place once you have it
aligned.