Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 9/35
Examine the four bearings on the Z Carriage and take
note of the V-shaped gap between the two black
wheels as shown in the image below.
Routing the Belt
When the Z Carriage is attached to the rails properly, a
portion of the belt should be exiting the top and
bottom of the Z Carriage as shown in the image below.
Slowly pull the bottom portion of the belt and loop it
over the Idler as shown.