Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 5/35
NOTE: One side of the wasteboard has countersunk holes.
This is the top. The countersinks are to provide clearance
for the heads of the button head caps screws. Installing
the wasteboard upside down will result in clearance
issues with the hardware.
XZ Assembly
The X Carriage and Z Carriage are shipped together in
the same box along with two small bags that contain
two springs and the Idler Assembly.
The Z Carriage is the smaller of the two carriages
shown in the image below. Carefully remove the Z
Carriage from its protective wrapping; ensure that the
belt is not damaged or removed from its initial
installation location.
Install Idler