Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 4/35
Item Part Qty Description
 Leveling Feet 4
install on underside of
end plates
Base Frame Assembly
Using the hardware found in the package labeled
‘wasteboard’, assemble the base frame of the
machine.
Note: There are 18 screws in the bag, but you will only be
using 12.
Begin by installing the leveling feet in the corners of
each End Plate. Set the 3/4” wasteboard across the
front/rear plate.
Loosely attach the wasteboard into the End Plates with
the included M5x20mm screws. (Note: you will have 6
extra screws)