Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 33/35
After your wires have been connected to the correct
ports, install the enclosure cover using the included
M6 x 8mm Socket Head Cap Screws (one on each side).
After the enclosure is on, check the travel of your X
axis to make sure there is enough slack in the wire
bundle to allow full travel. Just slide the X-axis to its
farthest extent on both sides and ensure the wires do
not pull.
When you are happy with the travel, and wire routing,
pull the grommet down the bundle and push it into
place on the port. This will keep your wires together
and provide a litte bit of strain relief on the bundle.