Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 30/35
When installing the controller, ensure the orientation
matches what is shown in the picture. The USB and
Power ports should be facing to the right (as viewed
from the same direction as the picture)
After the controller has been installed, route the
cables from the stepper motors to the controller.
The X/Z Assembly works best by using 4 of the zip-ties
to create a wire bundle, with a zip tie placed ever 4–6
inches down the bundle.