Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 26/35
Install Z-Axis
Install the Z-axis switch plate by rst installing 2 25mm
x 1mm standos, using the M5x10mm BHCS included
with the kit.
PROTIP: It will be easier to install the plate if you
do not tighten the standos at this time.
With the standos installed, place the Z-axis plate in
place, and secure with 2 more M5x10mm BHCS as
shown in the photo below.