Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 22/35
Working your way towards the other end of the Y-Axis
Rail, run the belt between the rail and the anged
idlers. Pushing from both sides of the idler, force the
belt up and towards the idler. You can also use the
1.5mm hex key to lift the belt between the idlers. Once
the belt is accessible, wrap around idler.
Using another M5x10mm screw, tension the belt clip
against the front of the machine.
To get the proper tension on the belt, pull enough
belting through the clip (underlapping) so you can
push the belt clip, with your nger to within about 1/4”
of the End Plate or close enough where the M5x10mm