Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 21/35
The proper routing is: Up from the bottom, Down
through the top, Back towards the front. Pull about 2″
of belting back towards the front. Ensure the
overlapping teach line up and interlock.
After the belt has been run through the clip, ensure
the teeth have interlocked with each other and there is
roughly 2 inches (50mm) of underlapping belting.
Using one of the M5x10mm screws, tighten the belt
clip against the plate. Double check the teeth
remained interlocked.