Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 19/35
Using the box as a support, position the gantry system
into the base frame. You may need to loosen the base
frame assembly if there is not enough clearance to
insert the rails. Slide the gantry system in from the
side. If you have two people, you can also set it in from
the top.
Using a carriage box to support the entire gantry (from
the center) Install 2 screws, diagonal from each other,
on both sides of the front plate. The screws should
only be nger tight at this point.