Assembly Instructions

16/01/2019 Shapeoko Assembly Guide - Carbide 3D
https://docs.carbide3d.com/assembly/shapeoko/s3/ 12/35
When the belt is tight, use a 4mm hex key and 10mm
wrench to tighten the Idler Assembly as shown in the
image below.
Install Springs
Lay the X/Z Carriage on one of its sides as shown in the
image below. Place one of the spring’s loops around
the Z Carriage post as shown in the image below.
Pull up on the spring and attach the other loop to the
X Carriage post as shown in the image below.
Turn the X/Z Carriage on its other side and attach
second spring in identical manner as shown in the
image below.