Assembly Instructions

Raise the TWO uprights and place into locked
position on the bracket as shown.
5.
Check clearance area
4.
Be sure to place each lid upright in the slotted
position to keep from falling during loading and
unloading.
Then slide the mounting plate (C) over the
threaded posts inside the cargo carrier.
6.
Place the mounting bracket (A) through the
pre-drilled holes from below the vehicle
cross rails as shown above.
Thread two knobs (B) evenly and loosely – do not tighten all the way at this
point. Repeat steps until all 4 mounting brackets (A), all 4 mounting plates
(C) are in place and the 8 knobs (B) are loosely in place. Make sure cargo
carrier is centered on vehicle. Then tighten all 8 knobs evenly and securely.
Knobs
6
INSTRUCTIONS / INSTRUCCIONES / INSTRUCTIONS
Mounting Plate
Mounting Bracket