Assembly Instructions

Engage the bale latch on the hinge side of the cargo
carrier. This bale latch stays in the closed position
going forward. Then secure with clip hook.
3.
Close the cargo carrier. Pull up on the lid on the
hinge side of the cargo carrier to be sure hinge
tabs are engaged.
Carefully place the assembled cargo carrier
on the top of roof rack cross rails and center
on vehicle. Check for clearance of rear hatch
and antennas.
4.
Set cross rails at 22" on center.*
22"
Be sure to align the mounting holes in the box
bottom on each side of the cross rails.
Mounting
Hole
Mounting
Hole
*Cross rails on some vehicles are not adjustable and may require additional holes drilled into the bottom of the cargo carrier to match
the fixed position width. If this is the case, center the carrier on your cross rails and mark the holes using the mounting plate. Drill the
holes with a 5/8” drill bit and be sure to drill holes while not on vehicle. Mounting plate must be on a flat area and parallel with the other
hole patterns.
clip hook
INSTRUCTIONS / INSTRUCCIONES / INSTRUCTIONS
5
Front of
carrier
bale latch