User guide

3. Settings3. Settings
3.3.1 FACTORY MODE-IMAGE, PARK
 IMAGE
Adjust navigation position and size
H-POSITION : Move display horizontally
V-POSITION : Move display vertically
FACTORY mode – Press ◀
◀◀
◀ button 2 seconds long on the remote control.
 PARK
PAS ENABLE : Selecting whether to display the
parking guide line or not on rear gear
(default : ON)
PAS SETUP : Adjusting the position of the
parking guide line
RADAR ENABLE
-11-
REAR TYPE : Choose rear camera recognition
* LAMP - Detecting the rear view camera
via rear lamp (Installer must connect “Rear-C”
cable of the power cable to the rear lamp of
the car.)
*CAN - Detecting the rear view camera
by CAN signal (Installer must connect “CAN”
cable of the power cable to the “CAN” cable
of the car.)
SAFE ENABLE : If your car is connected with
CAN cable and it is in ”ON” state, you can
NOT watch DVD or A/V except original image
or navigation while driving. At that time the
screen get back to the main (default : OFF)
RADAR ENABLE : When set the gear to “R”,
Display PDC
※After installing rear camera : DIP S/W #7 must
be put down (ON). Refer to page 9.
www.car-solutions.com
[e-mail]
Car-Solutions.com