User manual

2.7.1 Setup for rear view camera
www.car-solutions.com
16
UTIL - REAR SELECT
Selecting how to detect the rear view
camera
LAMP : Detecting the rear view
camera via rear lamp (Installer must
connect “Rear-C” cable of the power
cable to the rear lamp of the car.)
CAN : Detecting the rear view camera
via CAN signal (Installer must connect
“CAN” cable of the power cable to the
“CAN” cable of the car.)
• On installing rear view camera : Pull down
DIP switch pin#7 to set it as “ON”. (Refer
to page9.)
PARK
PARK ENABLE : Selecting whether to display the parking guide line or not
on rear gear (default : ON)
PARK SETUP : Adjusting the position of the parking guide line (available
in PARK SETUP -> V-POSITION, H-POSITION)
SAFE ENABLE : If your car is connected with CAN cable and it is in ”ON”
state, you can NOT watch DVD or A/V except original image or
navigation while driving. At that time the screen get back to the main
(default : OFF)
a. If you want to get to the FACTORY mode, set the gear as rear state
and press “LEFT” button 2 seconds long on the remote controller or
the keypad. (as shown left top)
b. If you set ‘PARK ENABLE’ as “ON” state, there will be the rear view
parking guide line. (as shown right top)
FACTORY mode – Press ◀ button 2 seconds long on the remote controller.
Car-solutions.com