Installation manual

2.7 Touch Screen Panel Calibration
www.car-solutions.com
14
① First of all, press ◀ button on remote controller for 2
seconds. Then you can enter the FACTORY mode.
② Set “YES” after CALIBRATION option is selected as
shown above.
③ After that “touch calibration” caption appears on
screen for about 2 seconds as shown above.
When it disappears you can calibrate the touch
screen. (Just touch on screen.)
If calibration was performed, “success” caption
will appear. If not, you will see “failure”.
If you use external touch screen panel for connected DVD player, TV tuner, DVB-T
receiver control by OSD buttons, which will emulate remote controller buttons of
these devices, you should calibrate the connected touch screen panel.
Car Solutions