Installation manual

www.car-solutions.com
13
2.6 Parking Guideline setting
FACTORY mode – Press ◀ buttons on the remote controller for 2 seconds.
① Set “ON” in “PARK ENABLE” line in the PARK section as shown left. (default –
OFF)
② If you turn on rear gear after setup, parking guidelines will appear on screen as
shown left. Now if you push “OK” button, you can see “H-POS” on the left of
screen. Then adjust horizontal position of the parking guidelines.
③ After horizontal position adjustment, press “OK” on the remote controller. Then
you will see “V-POS” on the left of screen. Adjust vertical position of the guideline.
Car Solutions