User manual

13
2.5 Parking guide line setting
FACTORY mode – Press ◀ button 5 seconds long on the remote controller.
www.car-solutions.com
PARK
* PARK ENABLE : Selecting whether to
display the parking guide line or not on
rear gear (default : OFF)
* PARK SETUP : Adjusting the position of
the parking guide line (available in PARK
SETUP -> V-POSITION, H-POSITION)
* SAFE ENABLE : In case of Connecting “
Safe” wire from the power cable to the
hand break,
ENABLE – OEM Picture displays in Drive
gear position
DISABLE – No display locked in any gear
position
PARK - ENABLE
A. If you set ‘PARK ENABLE’ as “
ON” state, there will be the rear
view parking guide line.
(as shown left picture)
B. Press the OK button of remote
controller, ‘’H_POS
’
’
’
will be shown
on the right and control moving
in horizontal direction.
PARK - ENABLE
A. Press the OK button of remote
controller one more, ‘’V_POS
’
’
’
will
be shown on the right and control
moving in vertical direction.
Car-Solutions.com