User manual

Andover Continuum
Infinet
Andover Continuum
Infinet Controllers-7
Infinet Infinet
Continuum Input / Output Modules
TheContinuumI/Omodulesfeatureasleek,lightweightcasinganda3-positionfrontcover
foreasy,hands-freeaccess.Built-inquick-releasefastenersatthebackofeachI/Omoduleare
providedforDINrailmounting,notoolsrequired.Thesefastenerssnapintoalockedpositionfor
panel mounting. Input and output connectors are located at the bottom of each I/O module and
are removable for easy field access and maintenance.
The I/O modules communicate with the NetController CPU module using ACC-LON RS-485
communications(FTTmodulesarealsoavailable,describedlater).TheI/Omodulesslide
togetherviabuilt-inconnectorsoneitherside,sonetworkexpansionisquickandeasy.Both
power and communication signals feed through these connectors. A single module or groups of
I/Omodulescanberemotelylocated,connectedusingapprovedcable,andunlessotherwise
stated are powered from a local DC power supply. Each I/O module features its own network
push-button,thusreducingcommissioningtime.AllmodulesareCEapproved.
UI-8-10 Input Module
8UniversalInputs(supervised,voltage,thermistor,digital,counter).Powerrequirementsare
10-28VDC,0.7watts.
5 volt input, 10 bit resolution UI-8-10
10 volt input, 10 bit resolution UI-8-10-10V
DI-8 Input Module
8Digitalinputs(digital,counter)canacceptvoltfreecontact-24VDC/ACmax@0.5mA.2
countersat10Khzmax.6countersat10Hzmax.Powerrequirementsare10-28VDC,0.7watts.
Input Module DI-8
DI-6-AC Input Module
6 AC inputs for on/off status. Wire AC or DC voltage up to 250V directly to the terminals.
Powerrequirementsare24VDC,0.7watts.
24-120V (>20V = On; <12V = Off) DI-6-AC
120-240V (>90V = On; <45V = Off) DI-6-AC-HV
MI-6 Input Module
6twowire0-20mAinputs,direct-wired.Powerrequirementsare24VDC,3.8watts.
Input Module MI-6
DM-20 Input Module
20 channel-selectable inputs or outputs drive LEDs and/or sense switches on a graphic
annunciation panel. May be used with DIO/20 expansion board and solid state relays for higher
loadapplications.Powerrequirementsare24VDC,0.5watts.
Input/Output Module DM-20
AO-4-8 Output Module
4Analogueoutputs,8-bitresolution.0-10VDCor0-20mAoutput.Powerrequirementsare24
VDC,3.8watts.
With 3 position override switches/potentiometers with feedback AO-4-8-O
Without overrides AO-4-8
DO-4-R Output Module
4digitaloutputs,FormCrelays(5A,240VAC/30VDC).PWMcontrolof0.1seconds.Combine
2outputsinto1tri-state.OutputstatusLEDs.Powerrequirementsare10-28VDC,2.8watts.
With 3 position override switches with feedback DO-4-R-O
NetControllers I & II I/O Modules