Use & Care Guide
OPERATING INSTRUCTIONS
To use as Flashlight – up to 15 hours:
Simply slide Eco-i-Lite out of the Induction Charging base.
Push Flashlight push button to select modes – Hi/Lo/Flasher/Off.
Charge will last 15 hours on Lo and 3 hours on Hi.
To use as Power Failure Light – up to 15 hours:
Keep Eco-i-Lite plugged into AC outlet and 10 LEDs will automatically turn on Keep Eco-i-Lite plugged into AC outlet and 10 LEDs will automatically turn on
Lo mode during power outages.
To use as Nightlight:
Keep Eco-i-Lite plugged into AC outlet with Nightlight/Worklight slide-switch
on AUTO-LO or AUTO-HI, and 6LED Auto Sensor Nightlight will automatically
turn on when area gets dark. LEDs will turn off when there is light again in the
area.
Use the ON slide-switch position to turn nightlight on (stays on continuously).Use the ON slide-switch position to turn nightlight on (stays on continuously).
To use as Worklight:
Simply slide Eco-i-Lite out of the Induction Charging base.
Slide the Nightlight/Worklight slide-switch to ON position. 10LED Flashlight
turns off when 6LED Worklight is on.
WARNING
NOTE: This equipment has been tested and found to comply with
the limits for a Class B Digital Device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This equipment complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Modications not authorized by the party responsible for compliModications not authorized by the party responsible for compli-
ance could void user’s authority to operate this equipment.
1. Close supervision is necessary when this unit is used near children.
2. Use only the charger supplied by the manufacturer to recharge.
3. To reduce the risk of electrical shock, do not put the unit in water or other
liquid. For cleaning, use a soft dry cloth. Do not place or store appliance where
it can fall or be pulled into a tub or sink.
4. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. THERE 4. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. THERE
ARE NO SERVICEABLE PARTS INSIDE.
HIGH BEAM
LOW BEAM