User's Manual

Cursor your internet enabled smart phone browser over the hyperlink and click to see the current position

displayed on Google Map. You can copy the link straight onto Google Earth if running on a PC, or use

Bluetooth to transfer the hyperlink from your cellphone to your PC, where you can click on the hyperlink and

view the position on a map.

To Disable the GEO-FENCE function, send the command "NOSET".

OTHER COMMANDS

"FIX" will respond with the immediate GPS Fix. If the GPS is OFF when this is issued, it may take several

minutes to lock a satellite solution and deliver a fix.

"GETSIG" will respond with the GSM 1 to 5 bar measurement and a SSI signal strength Indicator. The GPS

will show the number of satellites being tracked and fixes obtained. You need at least 3 Satellites for a fix.

"INFO" Will respond with the Vigil backup battery %, boat battery Voltage, and temperatures-Ambient,

Maximum recorded and Minimum recorded since last reset command ( 'TEMPR').

"NOFIX" turns OFF the GPS receiver and saves power. Send this to terminate location based services.

"TAMPER" activates the tamper sensing. The Factory sets Vigil into Tamper mode when shipped.

"NOTAMPER" Disables the TAMPER sensing. Use this if working on installation and you don’t want to be

sent messages. Don’t forget to enable it when finished.

"SIREN" activates the SIREN / STROBE( if these are installed) upon a Geo-fence transgression. These are

accessories not normally supplied with Vigil. The sirens we supply will trigger on a pulse from Vigil and

remain on for a period set by an internal timer in the siren. Cutting the wires to the siren will not disable it

once activated.

"NOSIREN" disables the Siren and Strobe if issued before a transgression is activated. If the Siren is

already activated, it will not turn it off. It will be up to the siren internal timer to time-out and reset itself. This

command only stops further triggering of external alarm devices. Contact us for other programmable siren

activation options.

SPECIAL COMMANDS

"REPORT xy//info" sets Vigil up to send an AUTOMATIC "INFO" report every "xy" hours.

"TEMPRESET" alone, resets the Temperature Logs to present ambient temperature.

"TEMPRESET <>F(

or C)<> Max Temp// Min temp " F or C selects units, <> is a space, Max and Min

temps sets the maximum and Minimum ALERT temperatures, Range is 14 F (-10 C) to 176 F ( 80 C).F:

Fahrenheit,

C: Centigrade. Eg: TEMPRESET F 110//38

"HELP" responds with Help info on command syntax.

TEMPDEL n Temperature delay in minutes (n). Use to reduce transient alarms.

PWRDEL n Power loss alert delay in minutes (n). Use to reduce transient alarms.

ARM Activates SMS messaging ( Factory default)

DISARM Disables all SMS messaging.

ASK<>code Used in USSD enabled networks to request network subscriber data like prepaid simcard

balance amount. If code to get simcard dollar balance is say *120# from your cellphone,

then send Vigil the code as ASK *120# and it will return the network message with this

information. Does not work with voice-only services. Requires USSD service.

PLE Power Loss alert ENABLE.

PLD Power Loss alert DISABLE.