User's Manual

2
Set up your phone to send a text message (SMS) TO the phone number issued with the SIMCARD
that
you just loaded into Vigil. The SIMCARD phone number will have been issued along with the SIM card by
the network provider. The first message you must send Vigil is your cell phone number
. Send the following
text message::
ADDPHONEn<>88888888<>+(country code)(area code)(your cellphone number) (n is ph 1 to ph 4.)
eg : ADDPHONE3 88888888 [phone] (This is loaded as ph # 3)
Spaces are indicated by <>. Don’t insert any spaces in the phone number itself. The eight 8's are a factory
password that you should change later.
Now send this off. Vigil should respond with a confirmation message. If no response is received within about
3 minutes, it means it either did not receive the message or there was a syntax error in the command.
If this worked, you can close the unit up again carefully, making sure the o-ring is clean and seated properly.
Incorrect installation of O-ring voids warranty.
ADDING PHONE NUMBERS
You can store up to four phone numbers. Add them using
ADDPHONEn<>PASSWORD<>+(country code)(area code)(your cellphone number)
eg : ADDPHONE3 88888888 [phone] (this is loaded as Ph. # 3)
LOADING the SIMCARD PHONE NUMBER
Most SIMCARDS do not have a phone number stored internally, so you need to load the number assigned to the SIMCARD
by the network provider. Do this by sending Vigil the following command:
DEVPH<>+(country code)(area code)(SIMCARD phone number)
eg: DEVPH [phone]
If you don’t add the Device Phone number, vigil will still work, but the TIME will not be updated from the network
.
LIST REGISTERED PHONES
To check the four recipient phone numbers stored in Vigil. Send the following command:
GETPHONE
REMOVING a PHONE NUMBER
Send the following text to your vigil
REMOVEPHONEn <>PASSWORD<> +(country code)(area code)(phone number) (n is ph # 1 to 4)
eg: REMOVEPHONE2 <>88888888 [phone] ( this removes ph # stored as #2)
To change a number, you can load the new number over the old using ADDPHONE. If there is no room left, vigil will advise
with a message.