User's Manual

2
LOADING the SIMCARD PHONE NUMBER
Most SIMCARDS do not have a phone number stored internally, so you need to load the number assigned to the SIMCARD
by the network provider. Do this by sending RAM3G the following command:
DEVPH<>+(country code)(area code)(SIMCARD phone number)
eg: DEVPH [phone]
If you don’t add the Device Phone number, RAM3G will still work, but the TIME will not be updated from the network
.
LIST REGISTERED PHONES
To check the four recipient phone numbers stored in RAM3G. Send the following command:
GETPHONE
REMOVING a PHONE NUMBER
Send the following text to your RAM3G
REMOVEPHONEn <>PASSWORD<> +(country code)(area code)(phone number) (n is ph # 1 to 4)
eg: REMOVEPHONE2 <>88888888 [phone] ( this removes ph # stored as #2)
To change a number, you can load the new number over the old using ADDPHONE. If there is no room left, RAM3G will
advise with a message.
CHANGING PASSWORD
To change the password, send RAM3G the following text message;
PASSWORD<>OLD password<>NEW password
eg: PASSWORD 88888888 12345678
SETTING and USING the GEO-FENCE
From your cellphone, send RAM3G the following Geo-Fence command:
'SET'
It will respond with a confirmation SMS that it has a new HOME location for the geo-fence.
That’s all…. RAM3G will now send a transgression report if it moves outside the geo-fence radius.
Nothing other than external alarms will be sent while within the new Geo-fence zone. It will of course be
monitoring any bilge levels or security devices all the time. You can at any time send commands and receive
information while in either Geo-fence "guard" mode, or after a fence transgression, when in "Tracking" mode
( when the SET command has been issued).
After the initial transgression, RAM3G will send a position report every 5 minutes. You can program RAM3G
differently, to send other automatic position reports either based on time since the last position (FIX) or
distance from the last Fix, or BOTH. At any time you can request an immediate position report by sending: