User Guide

J
) Installing the Claris Cartridge (F9 is on)
1. Rinse cartridge under running water and insert
into water tank reception. Close cartridge holder.
2. Fill tank with cold water. Push and hold the
P button:
FILTER NO. Touch ST@RT. NO starts blinking.
3. Touch red arrow once:
FILTER YES. Touch ST@RT to
confirm.
4.
INSERT FILTER / WATER PORTION. Place a large
container (30 oz.) under the frother and push the
HOT WATER button. FILTER RINSING. After ~90
sec.:
YOUR MACHINE IS HEATING then SELECT
PRODUCT.
The F9 automatically reminds you when it’s time to
replace the cartridge. Please note: When the Claris
program is activated, the decalcifying monitor is
turned off .
K) Replacing the Cartridge
The display shows REPLACE FILTER / SELECT
PRODUCT
• Remove old filter, rinse new filter under running
water and insert (see above). Place a large container
(30 oz.) under the frother. Turn the machine off.
Now, push and hold the
RINSE button.
•
WATER PORTION / INSERT FILTER. Push the
HOT WATER button.
Important: If message REPLACE FILTER does not
appear after 6 weeks, you must still replace the filter.
L) Cleaning with Special Tablet
This cleaning cycle removes coffee oils inside the
machine. This message will appear after 200 cups of
coffee:
CLEAN MACHINE / SELECT PRODUCT. Takes
less than 10 minutes!
Important: Only use special round cleaning tablets!
Important: Once started, do not interrupt the program!
1.Fill water tank. Push and hold the RINSE button.
EMPTY TRAY. Please note: You must remove the
tray for 20 seconds, even if it is empty. Replace tray.
2.PRESS MAINT. Push the RINSE button. MACHINE
CLEANING. After a moment the display shows
TABLET / PRESS MAINT.
3. Drop one white tablet into the "ground coffee funnel."
Push the RINSE button. MACHINE CLEANING.
After a few minutes:
EMPTY TRAY. Carefully lift,
remove and empty tray and replace. The F9 returns
to its standard message SELECT PRODUCT and
resets itself.
M) Decalcifying
If a water hardness level is selected (see Operating
Instructions), the decalcifying monitor is active. The F9
needs to be de-calcified when the message
MACHINE
SCALED SELECT PRODUCT
appears.