Technical data

20
ENA 5
Place the cup under the coffee spout.
k T Press the Rotary Switch to start the coffee
preparation.
1 CUP, the pre-set amount of water
flows into the cup. Preparation stops
automatically.
To ensure that the Easy Cappuccino Frother
works perfectly, it should be rinsed and
cleaned regularly (refer to Chapter 4
‘Maintenance – Easy Cappuccino Frother’).
Cappuccino with the 2-stage frothing nozzle
Precondition: READY appears on the display
and the coffee spout is set at the 1 cup position.
Push the 2-stage frothing nozzle to the
lower position.
Place a cup of milk below the 2-stage
frothing nozzle and immerse the nozzle in
the milk.
If the nozzle does not reach into the cup, lift
the cup towards the nozzle.
g T Turn the Rotary Switch until STEAM is
displayed.
k T Press the Rotary Switch.
HEATING
READY appears as soon as the ENA is
sufficiently heated.
l T Turn the switch to position m.
STEAM, the milk is foamed by the hot
steam.
T
T
T
E
y T Turn the switch to position o when the
milk foam has reached the required
consistency.
You can prepare more steam within about
40 seconds.
Place the cup under the coffee spout.
k T Press the Rotary Switch to start coffee
preparation.
1 CUP, the pre-set amount of water
flows into the cup. Preparation stops
automatically.
To ensure that the 2-stage frothing
nozzle works perfectly, it should be
rinsed regularly (refer to Chapter 4
‘Maintenance – Dismantling and rinsing
the 2-stage frothing nozzle’).
Heating milk with the
Professional Cappuccino Frother
Precondition: READY appears on the display.
Remove the protective cover from the
Professional Cappuccino Frother.
Connect the milk pipe to the nozzle.
Insert the other end of the milk pipe into a
milk carton or connect it to a milk
container.
Place a cup under the nozzle.
Set the selector lever of the nozzle to the
milk
t position.
E
T
T
T
T
T
T