Technical data

18
ENA 5
Place one level measuring spoon of
pre-ground coffee into the filler funnel.
Remove the filler funnel.
Close the powder chute.
1 CUP
k T Press the Rotary Switch to start coffee
preparation.
1 CUP, the pre-set amount of water
flows into the cup, preparation stops
automatically.
READY
It is also possible to prepare two cups of
pre-ground coffee. To this purpose place
two level measuring spoons of pre-ground
coffee into the filler funnel. Turn the Rotary
Switch to
2 CUPS and press to start
coffee preparation.
One-off setting before and during
preparation
The coffee strength can be changed before
preparation or during the grinding operation.
The following coffee strength options are possible
for 1 coffee:
Mild
Normal
Strong
2 coffees are always prepared with the
coffee strength ‘mild’.
The pre-set amount of water can be
changed during the brewing operation by
turning the Rotary Switch.
One-off settings before and during coffee
preparation always follow this model. These
settings are not saved.
Example: Changing the coffee strength of
1 coffee before preparation from
NORMAL
to
STRONG.
T
T
T
E
Z
Z
Z
E
E
Precondition:
READY appears on the display
and the coffee spout is set at the 1 cup position.
Place the cup under the coffee spout.
g T Turn the Rotary Switch until STRONG is
displayed.
k T Press the Rotary Switch until STRONG is
displayed.
During grinding the coffee strength
STRONG is displayed.
1 CUP, the pre-set amount of water
flows into the cup, preparation stops
automatically.
READY
Entering a default setting for the amount of
water for a cup size
A default setting can be entered for the
amount of water for 1 coffee. When
preparing 2 coffees this amount is
dispensed per cup.
Precondition:
READY appears on the display
and the coffee spout is set at the 1 cup position.
Place the cup under the coffee spout.
k T Press the Rotary Switch and hold it down.
During grinding the strength of the coffee
is displayed.
k T Continue to hold the Rotary Switch down
until
ENOUGH COFFEE ? appears.
The coffee flows into the cup.
k T Press the Rotary Switch again when enough
coffee has been filled into the cup.
OK, the default setting for the amount of
water for one coffee has been entered.
READY
This setting can be changed at any time by
repeating the above procedure.
T
E
T
E